100PCS of 1.8L wall mounted humidifiers are ready to ship out
Recently , our factory produced 100pcs of 1.8L wall mounted humidifiers for Canada customer . The customer told us , these humidifiers will be used in a school .
For the wall mounted humidifier , not only be used in school ,but also widely used in hospital ,office and other home rooms .
In some production areas, the air humidity must be maintained at more than 50%RH, otherwise it will cause paper crimp, electrostatic accumulation, paper jam, paper roll fracture and faulty overprinting.Especially in winter, the internal humidity of the workshop even drops to 20%, because heating the cold air will reduce the humidity of the air.
Product features :
1. Humidity controller responds to environmental temperature change in real time
2. The controller has built-in light sensors, which can automatically identify the intensity of light and provide two operating parameter settings during the day and night.
3. According to different humidity control needs, the controller can set the humidity upper limit and humidity hysteresis. The setting parameters are automatically saved.
Product introduction :
The 1.8L ultrasonic humidifier uses an integrated atomizing movement inside. No mechanical drive, quiet and no noise, high atomization efficiency, low failure rate, simple maintenance. The fog particle diameter is only 1-10u, and the maximum RH can reach to 99%.
The wall mounted humidifier is designed to be mounted on the wall and is equipped with standard water supply port, water discharge port, etc., in which it could be connected with tap water, and water softener is for option in order to meet the requirements of non-calcified white powder pollution for different water quality.
1.8L humidifier is equipped with digital humidity automatic control system, automatic segmentation control during the day and night, the control accuracy is within 3%.
