Moisture Absorber Dehumidifier

Product Photos:

Do you need to close the window when dehumidifying the room?

When dehumidification is required to close the window, we know that the principle of dehumidification is that when the refrigerant in the evaporator evaporates, a large amount of heat is absorbed, reducing the surface temperature of the evaporator, and liquefying the water vapor in the indoor air into water. This condensate will flow through the outlet pipe to the water pan and out of the room. At this point, you need to close the window, otherwise the outdoor humidity will enter again. It will lead to the danger of incomplete dehumidification, so it is best to close the window.

First, the lower the temperature setting during dehumidification, the better the dehumidification effect is proportional to the power consumption. When the dehumidification function is set, it is necessary to continuously reverse the reversing valve of the compressor system to cool it for a while, and the heating is maintained for a while to keep the room temperature constant. The baby compressor will run continuously without charging.

Second, in the dehumidification mode, compared with the cooling mode, save power, because the compressor operation in the dehumidification mode is intermittent, when the ambient temperature is higher than the ambient temperature, the set temperature is mostly lower than 27C for general When the cooling is at 35C, the compressor hardly stops. Intermittent operation saves more power when the compressor is turned on and off in dehumidification mode, but it must be remembered that the dehumidification function does not replace the cooling function.

When operating in dehumidification mode, the indoor fan is always running at low speed, the compressor is turned on and off, and the refrigeration system is used for intermittent refrigeration cycle. The resulting cooling capacity is primarily used to balance the latent heat of the indoor air. The water vapor turns into condensed water. A small portion is used to balance sensible heat, which is to lower some room temperature. When the compressor is stopped, the room temperature will gradually rise slowly. When it rises to about 1C above the set temperature, the compressor will automatically start, allowing it to circulate continuously, keeping the room temperature close to the set value, while removing a large amount of moisture from the air.

We know that in the spring, the dehumidification mode can be used. The dehumidification function is a very practical function. Save money not only without the need to purchase a dehumidifier. And the dehumidification speed is also relatively fast. It can help people effectively adjust the humidity in the air. Especially for residents on the first floor, if the weather is moderately large, you can try to purchase the dehumidification function. After dehumidification, it can reduce the feeling of dampness before dehumidification, and can eliminate the uncomfortable damp feeling.

For more details, please kindly contact our project development manager as below:

Hot Tags: moisture absorber dehumidifierChina, manufacturers, suppliers, factory, wholesale