Ultrasonic Mist Maker Fogger

Ultrasonic Mist Maker Fogger

7KG 10 HEAD Ultrasonic Mist Maker Fogger

1. The atomization film shakes up and down 1700KHZ to produce atomization effect

2. the atomizer maximum temperature control 55 ± 3 ° will automatically stop working

3. The atomizer water column represents a capacitor. In the environment with good water quality, it is recommended to use the atomizer of the steel water column. When the surrounding water capacitor is relatively high, the steel water column will automatically feel the operation and the scale is more. This can cause scale to get around the water column, causing the atomizer to fail. The water with more scale is recommended for steel float atomizer. The steel float is for upper and lower mechanical operation. It can also operate normally in environments with more scale.

4. In the case of the atomizer being out of the water, there is a possibility of burning immediately. This situation belongs to dry burning.

PRODUCT PARAMETERS

ADVANTAGE

1. The working process of the atomizer increases the temperature and the current decreases slightly. It avoids the increase of the temperature in the industry and increases the current. In the cycle leading to the temperature rise, it has the effect of preventing burnt plate.

2. The atomizer is tested three times before leaving the factory, the board assembly test, the finished product assembly test, and the package leak test.

3. The thickness of the circuit board is 1.5mm. It is thicker than the thickness of the peer 1.2mm.

4. The circuit board is equipped with an explosion-proof fuse at each outlet, which has the effect of releasing heat and burning.

5. The circuit board uses a triode to avoid the industry using diodes to generate heat problems

ATOMIZER USE PRECAUTIONS

1. When using this atomizer, please select DC power supply with output power greater than 300W and output voltage of DC46±2V.

2. When using a toroidal transformer, the square bridge must be installed with an aluminum heat sink of 5050MM or more, and a thin layer of thermal grease is applied between the square bridge and the aluminum heat sink.

3. When multiple atomizers are used in the same container, the outer casings of the atomizers must be electrically connected to each other to prevent electrical corrosion of the outer casing.

4. The mist generated by the atomizer must be forcibly removed by using a fan, and each group of atomizers retains a plane space of 600 cm2 to prevent the water temperature from being too high and shorten the service life of the atomizer.

5. The atomizer is suitable for atomizing neutral liquid (pH 5~8). The acidic liquid will corrode the outer shell and the atomized sheet. The alkaline liquid will affect the atomization amount, reduce the atomizer and atomization. The life of the piece and the failure of the water level switch caused damage to the atomizer.

6. Please do not damage the water level switch during the installation process, so as to prevent the atomizer from losing control due to the failure of the water level switch. The water level switch should be stopped after it is damaged, otherwise the atomized piece will dry and further damage the atomizer. At this point, it must be repaired by professional maintenance personnel before use.

7. When the atomizer works normally, please do not put your hand above the spray chamber of the atomizer to prevent ultrasonic damage.

8. The atomizer must be in the water to work normally. Please put it into the water before use and then turn on the power, and ensure that the surface of the atomizer is in a water state to avoid damage to the atomizer.

9. Disconnect the switching power supply before stopping the use of the atomizer, and then remove the atomizer from the water.

Hot Tags: Ultrasonic Mist Maker FoggerChina, manufacturers, suppliers, factory, wholesale